Epson LightScene EV-115 2200-Lumen WXGA Laser 3LCD Projector (Black) - Manual (Page 126)

126
Entering a Password to Use the Projector
If a password is set up and a Power On Protection password is enabled, you see a prompt to enter a
password whenever you turn on the projector.
You must enter the correct password to use the projector.
1. Use the number buttons on the remote control to enter the password.
Note: The default password is 0000 .
The password screen closes.
2. If the password is incorrect, the following may happen:
• You see a "wrong password" message and a prompt to try again. Enter the correct password to
proceed.
• If you have forgotten the password, make note of the Request Code: xxxxx number that appears
on the screen and contact Epson Support.