Lucent Technologies 6000 - Manual (Page 432)

10-6 MAX 6000/3000 Network Configuration Guide
Setting Up IP Multicast Forwarding
Examples of multicast forwarding configuration
HeartBeat Addr=224.1.1.1
HeartBeat Udp Port=16387
3 Set the Heartbeat Slot Time, HeartBeat Slot Count, and Alarm Threshold parameters to
specify the time, count, and alarm threshold. For example:
HeartBeat Slot Time=10
HeartBeat Slot Count=10
Alarm threshold=3
Source Addr=0.0.0.0
Source Mask=0.0.0.0
4 Exit the profile and, at the exit prompt, select the exit and accept option.
To enable multicasting on WAN interfaces:
1 Open the Connection profile for a multicast client site.
2 Open the IP Options subprofile and set Multicast Client to Yes. If appropriate, set the
Multicast Rate Limit parameter to specify a rate limit other than the default of 5.
Ethernet
Connections
0-101 Crofile1
Ip options...
Multicast Client=Yes
Multicast Rate Limit=5
3 Exit the profile and, at the exit prompt, select the exit and accept option.
Forwarding from an MBONE router on a WAN link
Figure 10-2 shows a multicast router on the WAN with local and dial-in multicast clients. This
example presents a sample configuration for the local MAX unit in the figure. The
configuration specifies the MBONE interface as a WAN link accessed through a Connection
profile # 4.
Figure 10-2. MAX acting as a multicast forwarder on Ethernet and WAN interfaces
Note: This example does not use heartbeat monitoring. If you want to configure the MAX for
heartbeat monitoring, see the sample settings in “Examples of multicast forwarding
configuration” on page 10-5.
Ethernet
MAX
T1
WAN
T1
T1
T1
BRI
MAXTNT POP
MAXTNT POP
Analog Modem
Win95
MAX
Win95
ISDN
modem
VAT
(Visual Audio Tools)
Multicast router
Win 95
VAT
(Visual Audio Tools)