Omega RD200 - Manual (Page 102)

－９８－
14. PRINTING FORMAT 14.3 Programming Zone Printing
4
Programming Flow Chart (RD2800)
<Example> Programming CH 1 and CH 3 to zone No.1, and CH 2 and CH 4 to zone No. 2
Operation screen
[Checking printing format]
+
     
[To be ready for programming]
     
[Selecting zone printing]
(3 times)
→
  
[Programming numbers of area]
→
   
[ Programming channel of 1st area]
→
  
[Programming channel of 2nd area]
→
  
Program 3rd area also. Program 4th area with same
procedure.
[To display step (4)]
   
+
Stored
If error display appears during
programming, press any key other
than and program again.
When it is normal, the next screen
appears.
When zones are divided into 3 or 4,
program channels up to 3 or 4 zones
.
The channel not selected in any zone
is skipped. Also, if the selection of
channel is overlapped or the skipped
channel is selected, error display
appears.
Press to display parameters.
The parameters are displayed
sequentially each time is
pressed.
Store the parameters into memory.
(Programming change mark is
printed.)
“+” mark is printed at the border of the
area.
* Fill unused digits with spaces.
Cursor
Standard
(1)
(2)
DISP
SHIFT DISP
SET
END
Zone scale
(3)
(4)
(5)
(6)
(7)
(8)
Cursor
Cursor
°F ENTRY
ENTRY
2
TAG
Numbers of divided area
ENTRY
∗
ENTRY
∗
ENTRY
ENTRY
SHIFT
SET
END
SHIFT
ENTRY
ENTRY
Remedial measure to
error display
Remarks 1
Channels programming
for 3rd or 4th zones
Remarks 2
For storing the parameter into memory,
return the screen to Step (4).
Remarks 3
Return to the display of
Step (4)
Selection and
overlapping of channels
Remarks 4
Checking parameters Reference 1
Storing Reference 2
Border mark Reference 3
Ref. 1
Ref. 2
Remarks 1
Remarks 1
Remarks 1
Remarks 1 Remarks 2
Various
keys
Various
keys
Remarks 3