Omega RD200 - Manual (Page 48)

－４４－
8. BASIC PROGRAMMING 8.4 Chart Speed Programming
Program the chart speed before operation.
• Press and simultaneously in the
operation screen to display the [Chart speed]
programming screen.
• For the remote contacts (option), read Section13.3.
• 0000mm/h can be set for RD2800. When 0000mm/h is
set, chart is fed at the speed of 12.5mm/h.
0001 to 0600 (mm/h)
or
0001 to 0200 (mm/h)
1
Programming Mode
 
2
Programming Flow Chart
<Example> From 20 mm/h to 50 mm/h
Operation screen
[Check]
＋
  
[To be ready for programming]
  
[Programming chart speed]
  
Error message appears?
Stored
Move the cursor to the character
display (a digit on the left) then press
or to switch “M” and
“H” alternatively.
Programmed chart speed
•
Cursor and programming lamp light.
• Cursor moves rightward when
pressing a numeric key.
Cursor moves rightward.
Cursor moves leftward.
Program the chart speed within 0001
to 0600 mm/h or 0001 to 0200
mm/min.
An error occurs if a value exceeds the
programming range or any space or
decimal point is entered.
The new programmed value is stored
into memory.
Memory colon blinks and the
programming change mark is
printed.
No printing, except time line, data printing and
programming change mark, is executed.

Cursor Chart speed (4 digits programming) (Fixed)

Memory colon
Programming lamp
Character display
Cursor
Speed unit
(H or M)
Chart speed
Cursor
Changing the speed unit (h/m)
YES
NO
When changing the chart speed, the programmed
parameters for [periodic data printing] (Section 11.7)
is cleared. (Default: Not programmed)
Influence to periodic data printing Remarks 2
Programming range
Speed unit
DISP
SHIFT
1
CHART
SET
END

0
CLEAR
5
DATA I
ENTRY
0
CLEAR
0
CLEAR
% /
Keys other than
SHIFT
Speed unit
（H/M）
Cursor
SHIFT
1
CHART

℃
If 150 mm/h or more is
programmed for the chart speed
Remarks 1