Omega RD200 - Manual (Page 51)

－４７－
9. PRINTINGS 9.2 Digital Data Printing
The measured value at the moment pressed is digitally printed with the plotter pen.
Operation screen
Digital data printing starts.
Interrupt?
Digital data printing ends.
(Approx. 5 min. at 20 mm/h)
* With this procedure, the printing
operation turns off.
Press and again to
turn it on.
(1) Press and then press . Digital printing of
measured value at the moment pressed starts.
(Note) When is pressed,   appears
for about 5 sec. Press while this message appears.
• Printing mode is different depending on the chart speed.
Chart speed Printing mode
0 to 499mm/h Analog printing is continued without interruption.
500 mm/h or
more
Analog printing is interrupted and data printing
is started.
(2) For interrupting the printing, press and then
press . Your recorder returns to the normal operation but
the printing operation is turned off. For turning on the printing
operation, press and then press again.
(3) When the digital data printing completes, your recorder returns
to the normal operation.
(1) RECORD ON status lamp is not lit.
(2) KEY LOCK status lamp lights.
<99 mm/h or slower> <100 mm/h or faster>
(Note) The above examples are for RD200. They are the same for RD2800.
Remarks
Example of Digital data printing (4-pen type)
YES*
NO
→
(Note)
→
DATA
PRINT
DATA
PRINT
ENTRY
REC
ON/OFF
ENTRY
DATA
PRINT
DATA
PRINT
ENTRY
DATA
PRINT
ENTRY
REC
ON/OFF
ENTRY
REC
ON/OFF
ENTRY
REC
ON/OFF
ENTRY Digital data printing cannot be executed in the
following conditions.