Omega RD200 - Manual (Page 37)

－３３－
7. PROGRAMMING 7.2 Key Functions
1 Functions by Pressing Single Key
Keys Names Functions
Display
Stops programming and returns to the operation screen. For certain programming items,
holding this key down for 2 seconds or more is required.
Space
(1) Deletes a numeric value or decimal point at an unnecessary digit.
(2) Programs “Blank” in the programming of [engineering unit] or [tag].
Program
Changes from programming mode (confirmation of parameters) to the programmable
condition. The programming lamp lights and the cursor appears at the programmable
leftmost digit.
Shift
Press this key first for using the key functions being indicated on the lower case of each
key.
Minus
Decimal
point
0
～
to
Nu
mer
ic
val
u
e
s
9
(1) Press these keys for programming a numeric value.
(2) For programming a decimal point, move the cursor to the next digit and press
before entering a numeric value.
(3) For deleting a decimal point, move the cursor to the next digit and press .
Up
Down
(1) For items to program by selecting from menu, this key steps the menu forward or
backward.
(2) For items to program parameters per channel in the programming mode
(confirmation of parameters), this key steps the channel No. forward or backward.
Left cursor Moves the cursor leftward.
Right cursor Moves the cursor rightward.
Entry
(1) Programming items common to channels: Stores the programmed parameter into
memory.
(2) Programming items per channel: Stores temporarily the programmed parameter in
the channel No. selected. Press + to store it into memory.
(3) Printing on/off, data printing or list printing is executed by pressing this key.
Printing
on/off
Selects on (enable) or off (disable) of printing. Press to go this selection active.
Feeding The chart paper is fast fed when holding this key down.
Data print
Prints the measured values at the moment the key is pressed digitally on the trace
printing. Press to go this printing active.
2 Functions by Pressing Two Keys Simultaneously
Keys Names Functions
＋ End Stores the programmed parameter, which is temporarily stored, into memory.
＋ To Inserts [～（）
] between minimum and maximum values.
＋ Clear Clears (Blanks) the programmed parameter displayed.
＋
Alphabetic
characters
Each time is pressed, characters step in the order of A, B, C …..
＋ List printing
Programmed parameters are printed as a list. Press to go this printing
active.
＋ % Programs “%” (percent) character.
＋ / (=)
Programs “/” (slash) character. This is also “=” in the subtract printing
programming mode.
＋ °C
Programs “
°C” (degree Centigrade) character.
＋ °F
Programs “
°F” (degree Fahrenheit) character.
SHIFT
SHIFT
SHIFT
SHIFT
SHIFT
SHIFT
SHIFT
SHIFT
SHIFT
SET
END
－
(-)
0
CLEAR
6
A～Z
9
LIST
%
°C
°F
/
ENTRY
DISP
SET
END
SHIFT
－
(-)
0
CLEAR
9
LIST
%
/
℃

CLOCK
SPACE
COPY(=)
SPACE
COPY(=)
CLOCK
SHIFT
SET
END
ENTRY
ENTRY
ENTRY
REC
ON/OFF
FEED
DATA
PRINT
/