Omega RD200 - Manual (Page 93)

－８９－
13. REMOTE CONTACTS 13.2 Terminal Allocation for Operation
This explanation is only for the remote contacts (option). Press and simultaneously for 3
seconds or more to display the “Terminal Allocation for Operation” programming screen. This allows allocation of
the desired functions to terminal Nos. 1 to 4 (EX 1 to 4).
1
Programming Mode
  
2
Programming Flow Chart
<Example> To allocate a chart speed of 3 and stop to
terminal Nos. 1/2 and operation record A to terminal No. 3:
Operation screen
[Check]
   
[To be ready for programming]
   
[Selecting operation]
   
[Selecting operation record
printing A]
   
[Selecting operation]
   
Temporarily stored
Stored
Press or to change
terminal Nos. Functions allocated can be
checked. The default allocation is as
follows:
Terminal No. 1:
Terminal No. 2: Printing on/off and 3 chart
speed selection
Terminal No. 3: Digital data printing
Terminal No. 4: List printing (List 1)
With   , 
and  , the terminal Nos.
are allocated automatically. Therefore,
when one of these functions is selected,
terminal Nos. 2 to 4 are not displayed.
See Section 13.1.
1 .
Press or to change
functions.
Displays Details
① None
② 
 Printing on/off and 3
chart speed selection
③
  Message printing
(No. 1 and 2)
④
  Message printing
(No. 1 to 5)
⑤ Operation printing A
⑥ Operation printing B
⑦ Operation printing C
⑧ Operation printing D
⑨ Digital data printing
⑩ List printing (List 1)
⑪ List printing (List 2)
⑫ List printing (List 3)
⑬  Totalization reset

Terminal No. Function
Ref. 1 3 sec. or more
（ ＋ ）
Checking other terminal Nos.
Terminal Nos. 2 to 4 are not
displayed.
Types of functions
0
CLEAR
5
DATA I
DISP
0
CLEAR
5
DATA I
SET
END
% /
/ %
Cursor
Ref. 2
Ref. 3
% /
＋
SHIFT
SET
END
ENTRY
ENTRY
ENTRY
Cursor
Cursor
Cursor
Reference 1
Reference 2
Reference 3