Omega RD200 - Manual (Page 70)

－６６－
11.OTHER PROGRAMMING 11.5 Alarm
2) With alarm output (option)
Operation screen
[Output check]
＋
  
[Programming check]
  
[To be ready for programming]
  
[Programming alarm point]
   
[Selecting alarm type]
→
   
[Programming relay No.]
   
[Programming alarm value]
   
[Only rate-of-change alarm]
→
    
[Only differential alarm]
→
    
Temporarily stored
Programming other alarm points?
＋
Stored
Follow the [Programming alarm point]
procedure and select the alarm point
to be deleted with .
Clear it by pressing and
simultaneously and perform
[temporarily stored] and [stored]
operation.
The relay Nos. in alarm output are
displayed. This will be blank unless all
of the relays are operated.
By pressing , the level
advances from 1 to 4 and the
channel advances to the next
channel and then the level of the next
channel advances. Press for
reverse operation.
1. Channel can be selected also with
or .
2. Channel advances by pressing
Then “FaiL” and “C.End” appear. If
these functions are selected,
program relay Nos. only.
This is for specifying terminal Nos. for
alarm output.
The relay No. for AH is displayed with
2 digits such as “00”. See Section
12.2.When programming “1” to “9”,
two entering methods of 1 to 9 or
01 to 09 are available. ( : space)
Programming range is 1 to 20.
Reference channel to be compared is
programmed in 1 to 4. (The
differential alarm cannot be selected
in a 1-pen type recorder because no
channel to be compared is existed.)
Store the [temporarily stored]
programmed values into the memory.
(A programming change mark is
printed.)
Numeric
keys
Numeric
keys
Cursor
Channel
Relay No.
Alarm value
Level
Alarm type
Measuring count
YES
NO
Channel to be compared
Relay No.
DISP
SHIFT
8
ALARM
ENTRY
SET
END
% /
°F
°F
°F
ENTRY
SHIFT
SET
END
Storing
Reference 7
To delete alarm point
/
%
Other alarm point check Reference 2
Programming alarm point Reference 3
Cursor appears only for
rate-of-change alarm.
Reference 5
Cursor appears only for
differential alarm.
Reference 6
Output check Reference 1
Relay No. Reference 4
Numeric
keys
Numeric
keys
When an error
appears
press any key other
than
SHIFT
Ref. 7
Ref. 6
Ref. 5
Ref. 4
Ref. 3
Ref. 2
Ref. 1
1
CHART
4
SCALE
to
/
SHIFT
0
CLEAR
/ %
/