Omega RD200 - Manual (Page 69)

－６５－
11. OTHER PROGRAMMING 11.5 Alarm
4
Programming Flow Chart
1) Without alarm output (option)
Operation screen
[Check]
＋
  
  
[Programming alarm point]
   
[Selecting alarm type]
→
   
[Relay No.]
   
[Selecting alarm value]
   
[Only rage-of-change alarm]
→
    
[Only differential alarm]
→
    
Temporarily sotred
Programming other alarm points?
＋
Stored
Follow the [Programming alarm point]
procedure and select the alarm point
to be deleted with .
Clear it by pressing and
simultaneously and perform
[temporarily stored] and [stored]
operation.
By pressing , the level
advances from 1 to 4 and the
channel advances to the next
channel and then the level of the next
channel advances. Press for
reverse operation.
1. Channel can be selected also with
or .
2. Channel advances by
pressing . Then “FaiL” and
“C.End” appear but these functions
are only available in the alarm
output (option).
Relay No. is fixed to “0” and no cursor
appears as the alarm output (option)
is not added. The relay No. for AH is
displayed with 2 digits of “00”.
Programming range is 1 to 20.
Reference channel to be compared is
programmed in 1 to 4. (The
differential alarm cannot be selected
in a 1-pen type recorder because no
channel to be compared is existed.)
Store the [temporarily stored]
parameters into the memory. (A
programming change mark is
printed.)
Numeric
keys
Numeric
keys
Cursor
Channel
Relay No.
Alarm value
Level
Alarm type
Measuring count
YES
NO
Channel to be compared
To delete an alarm point
DISP
SHIFT
8
ALARM
SET
END
% /
°F
°F
°F
ENTRY
SHIFT
SET
END
/
SHIFT
0
CLEAR
/
%
Storing Reference 6
Other alarm point check Reference 1
Programming alarm point Reference 2
/ %
/
Relay No . Reference 3
Cursor appears only for
rate-of-change alarm. Reference 4
Cursor appears only for
differential alarm.
Reference 5
Numeric
keys
Ref. 1
Ref. 2
Ref. 3
Ref. 4
Ref. 5
Ref. 6
When error appears
press any key other
than
SHIFT
4
SCALE
1
CHART
to