Omega RD200 - Manual (Page 54)

－５０－
9. PRINTING 9.4 Message Printing
For printing of a pre-programmed message, select the message No. and press .
Operation screen
   
Message printing starts.
Interrupt?
Message printing ends.
*
With this procedure, the printing operation turns
off. Press and then press again
to turn it on.
(1) RECORD ON status lamp is not lit.
(2) KEY LOCK status lamp lights.
(3) For the chart speed programmed at 150
mm/h or faster
When the remote contacts (option) is added,
message printing can also be executed by a
contact signal. However, this requires the
programming of the "terminal allocation". See
Section 13.2 for details.
(1) Press and simultaneously for 3
seconds or more.
(2) Select the message No. (1 to 5) to be printed with
or .
(Note) Refer to Section 11.10 for programming of
message.
(3) Press to start “Message” printing with a
plotter pen on the right side of the chart paper.
(Note) The “message” will not be printed completely
until the chart paper forwards several lines.
(4) For interrupting the printing, press and then
press . The printing operation is turned off
and your recorder returns to the normal operation.
For turning on the printing operation, press
and simultaneously again.
(5) When the message printing completes, your
recorder returns to the normal operation.
(Note) The above example is for RD200. It is the same for
RD2800.
YES*
NO
[No. selection]
(2)
(4)
(5)
Message printing cannot be executed
in the following conditions
.
Remarks
Execution with external
contact signal
Reference
Example of message printing
Message No.
（ ＋ ）
3 sec. or more
or
ENTRY
DISP
0
CLEAR
6
A - Z
% /
(3) ENTRY
→
REC
ON/OFF
ENTRY
/ %
ENTRY
REC
ON/OFF
ENTRY
REC
ON/OFF
ENTRY
REC
ON/OFF
ENTRY
0
CLEAR
6
A - Z
(1)