Omega RD200 - Manual (Page 92)

－８８－
13. REMOTE CONTACTS 13.1 Remote Contacts Functions
ON: Short OFF: Open
Functions Contact signal at terminal
• Program messages first. See Section 11.10.
COM
Message
EX1 EX2*
No.1 OFF
No.2 ON
(3) Execution of message printing
(No.1
and 2)
* When the trigger signals is sent (for 1 sec. or more) after selecting the
message No., the printing of programmed message starts.
(Note) Program “Printing on/off” to on with a key operation in advance.
Execution of message printing with key operation is also available.
See section 9.4.
(4) Execution of digital data
printing
Turn on (for 1 second or more) the terminal No. which the digital data
printing is allocated.
(Note 1) Program “Printing on/off” to on with a key operation in advance.
Execution of message printing with key operation is also available.
See Section 9.2.
(Note 2) During execution, retry of the
execution can be accepted just
once.
(5) Execution of list printing
(List 1, 2, 3)
Turn on (for 1 sec. or more) the terminal No. which the printing of list 1, 2 or
3 is allocated.
(Note) Program “Printing on/off” to on with a key
operation in advance. Execution of
message printing with key operation is
also available. See Section 9.3.
(6) Execution of operation record
(No. A to D)
Programming of the operation record position is necessary.
See Section 13.4.
Turn on (for 1 sec. or more) the terminal
No. which the operation record (No. A to
D) is allocated. During ON time, the
recording position shifts to 5 mm to the
right from the programmed operation
record position.
(Note) Program “Printing on/off” to
on with a key operation in
advance.
(7) Reset of totallization
Available in “Totalization” (option). The
totalized value can be reset at an interval time
programmed. It can be reset with a contact
signal, too.
For the contact signal applied to the remote contacts terminals, use a switch or a relay driven at 30V AC or
less or 60V DC or less or a manual contact for a very light load.
For trigger
1 sec. or more
ON time
ON time
5 mm
Operation record position
(10 to 90%)
1 sec. or more
Contact signal to terminals
1 sec. or more
1 sec. or more
Warning