Omega RD200 - Manual (Page 33)

－２９－
6. BASIC OPERATION 6.3 Fast Feeding of Chart Paper
When pressing , chart is fed at the speed of about 0.1mm/sec. When pressing more than 1
sec, chart is fed at the speed of about 10mm/sec.This operation is used for the following purposes.
(1) Setting the time scale line of the chart paper
(2) Checking of chart paper feeding operation
1. Condition ….. (1) For the fast feeding of the chart paper, the status KEY LOCK should be gone out.
(2) This function cannot be executed during printing.
2. Operation ….. Digital data printing is not executed during the fast feeding of the chart paper.
This function can be executed when the printing is off (RECORD ON goes out.).
Pull out the chart paper cassette slightly from your recorder. Turn the thumb wheel on the left side of the drum.
RD200 RD2800
Note: Even if the time scale line is set by manual chart paper feeding, a delay may occur due to the back lash
of the thumb wheel (gear).
Numeric values of 1 to 24 are marked on the left side of the chart paper. These are time scales when operating
the printing at a chart speed of 20 mm/h for RD200 or 25mm/h for RD2800.
Fast feeding condition and operation Remarks
Manual chart feeding Reference 1
Time scale (1 to 24)
Remarks 2
FEED
Thumb wheel
(Gear)
Thumb wheel
(Gear)
FEED