Omega RD200 - Manual (Page 63)

－５９－
11. OTHER PROGRAMMING 11.3 Skip (Channel Deletion)
When “CLEAR” (non-programming condition) is stored in the [Range/Printing range] programming, printing and
display of specific channels are skipped. Press and in the operation screen to display the
[Range/Printing range] programming screen. The default is no skip function programmed to any channel.
1
Skipping
If the skip function is programmed to the specified
channel, programmed parameters of [scale],
[alarm], [engineering unit] and [tag] of this channel
are also cleared. Program the parameters again if
the channels are restored to no-skipped status. Your recorder functions assuming that these
channels do not exist.
(1) Measured value: Disappear
(2) Bargraph: Disappear
(3) Data printing: Disable
(4)Trace printing: Overshooting to the minimum limit.
2
Programming Skip Flow Chart
<Example> Skipping CH 3 (3rd pen)
Operation screen
[Check]
＋
 
[To be ready for programming]
 
[Selecting channel]
or
(Press several times)
 
[Programming clear]
＋

Temporarily stored
Skipping other channels?
＋
Stored
Select a channel with or .
If a channel is selected with a numeric
key and the “CLEAR” is executed, the
channel being displayed before
changing programming ([1] in the flow
chart) is deleted.
You can check the range
programming of other channels.
Press or to change
channels. The skipped channels are
not displayed.
Store the [temporarily stored] skip into
the memory. (A programming change
mark is printed.)
Channel
Cursor
YES
NO
Channel
Channel
Operation of skipped channels
SHIFT 7
RANGE
DISP
SHIFT
7
RANGE
SET
END
% /
SHIFT
0
CLEAR
ENTRY
SHIFT SET
END
/ %
/ %
Storing Reference 2
Other channel check Reference 1
To select channels Remarks
Ref. 1
Ref. 2
Remarks