Unisys E-@CTION EFP9800 - Manual (Page 101)

EFP9800 ESC/POS Commands
3255 4073– 002 6– 11
Standard Mode
The horizontal direction of the fundamental calculation pitch is used to set the
print starting position from the beginning of the line.
Page Mode
Two types of fundamental calculation pitch are used to set the print starting
position from the beginning of the line, depending on the value of the Select
Print Direction in Page Mode command (1B 54 n). For more information see
“ Page Mode” later in this section.
•
If 1B 54 n = 0 or 2, the horizontal direction of the fundamental calculation
pitch is used.
•
If 1B 54 n = 1 or 3, the vertical direction of the fundamental calculation
pitch is used.
Set Line Spacing to Default Spacing
Sets the default spacing in either standard or page mode.
Hexadecimal Decimal ASCII
1B 32 27 50 ESC 2
Standard Mode
This command sets the line spacing to the default spacing as set in internal
switch 2 (either 6 lines per inch or 7.2 lines per inch). The command is only
available for the paper selected using the Select Paper for Setting Line Spacing
command (1B 63 31).
Page Mode
This command always sets the line spacing to 6 lines per inch, regardless of the
setting of internal switch 2. For more information see “ Page Mode” later in this
section.