Unisys E-@CTION EFP9800 - Manual (Page 45)

Diagnostics and Print Tests
3255 4073–002 3–7
Set Internal Switch Pack Values in NVRAM
Once you’ve chosen the emulation (in the previous section), you can specify
various printer functions by setting the switches on “internal switch packs.”
Caution
The DIP switches are set at the factory to predetermined settings. Change the
settings carefully to avoid changing other functions.
1. Turn the printer off.
2. Turn the printer to the back to access the DIP switches and write down the
current switch settings.
3. To put the printer into Switch Entry mode, set the DIP switches to the
following settings:
Switch
1
Switch
2
Switch
3
Switch
4
Switch
5
Switch
6
Switch
7
Switch
8
ON ON OFF OFF OFF OFF OFF OFF
4. Turn the printer back on.
The printer is now in Switch Entry Mode as indicated by the green Online
LED and the red Paper Status LED flashing. The green Slip In LED may be
on or off, depending on your input at the time.
5. Set the DIP switches according to the following table to select the internal
switch pack you want to use.
See the tables in the following four sections to determine the switch pack
you need for the emulation you have already chosen:
•
“EFP9800 ESC/POS Internal Switch Pack Settings”
•
“Ithaca Peripherals Proprinter Internal Switch Pack Settings”
•
“NCR 5021 Internal Switch Pack Settings”
•
“EF4270 Internal Switch Pack Settings”