Unisys E-@CTION EFP9800 - Manual (Page 241)

3255 4073–002 11–1
Section 11
MICR Commands and Parsing
These commands control the Magnetic Ink Character Recognition (MICR)
check reader, including how it parses the character strings on checks. This
section explains these commands.
The section that follows, “MICR Parsing,” describes how to create a parsing
format and how to create and maintain an exception table. If you would like a
copy of a software utility that performs these functions rather than developing
your own program using the command codes described in this section, please
contact Unisys. The software utility can be used as provided or can be
incorporated into your own application.
MICR Commands
Read MICR Data and Transmit
Reads the MICR data and either ejects the check or positions the check for
printing, depending on the value of n.
Hexadecimal Decimal ASCII Value of n (hexadecimal)
1B 77 n 27 119 n ESC w n 01 (Read MICR and Eject Check)
02 (Read MICR and Position Check for
Printing)
Define Parsing Format, Save in NVRAM
Defines and saves parsing format. See “Parsing Parameter String Options” on
the next page. Send this command at the start of day or use in the setup
application. If no parameters are selected, parsing is not performed.
Hexadecimal Decimal ASCII
1B 77 50
parameters 27 119 80
parameters ESC w P
parameters