Unisys E-@CTION EFP9800 - Manual (Page 106)

EFP9800 ESC/POS Commands
6– 16 3255 4073– 002
Select Page Mode
Changes mode from standard to page.
Hexadecimal Decimal ASCII
1B 4C 27 76 ESC L
This command collects and processes the data intended for printing on a
specific area of the paper. When the Eject Slip command (0C) is received, the
data is printed in the specified area and the printer returns to standard mode.
For more information see “ Page Mode” later in this section.
•
This command is valid only when input at the beginning of the line.
•
Half dots are not used in page mode.
•
The settings controlled by the following commands do not apply in page
mode (however, the settings are still valid when the printer returns to
standard mode):