Unisys E-@CTION EFP9800 - Manual (Page 142)

EFP9800 ESC/POS Commands
6– 52 3255 4073– 002
Notes for Bit 1:
•
The slip paper status becomes 0 (Printable) after paper is loaded and
becomes 1 (Not Printable) when the paper is ejected or the printer times
out.
•
When the slip paper is selected and the printer goes into the slip waiting
state, bits 5 and 6 of the third byte become 1 (No Paper) and bits 0 and 1 of
the fourth byte become 0 (Slip Selected) and 1 (Not Printable) respectively.
•
When the paper sensor for slip paper is disabled using the Select Paper
Sensor(s) to Stop Printing command (1B 63 34), the slip status does not
become 1 (Not Printable) even when there is no printable area. To avoid
this, confirm the printable area using the Transmit Status command (1D
72).
Notes for Bit 3:
•
The validation paper state becomes 0 (Printable) after paper is loaded and
becomes 1 (Not Printable) when the paper is ejected or the printer times
out.
•
When the validation paper is selected and the printer goes into the
validation waiting state, bits 5 and 6 of the third byte become 1 (No Paper)
and bits 2 and 3 of the fourth byte become 0 (Validation Selected) and 1
(Not Printable) respectively.
•
When the paper sensor for validation paper is disabled using the Select
Paper Sensor(s) to Stop Printing command (1B 63 34), the validation status
does not become 1 (Not Printable) even when there is no printable area. To
avoid this, confirm the printable area using the Transmit Status command
(1D 72).
The default values for n are:
•
when DIP switch 2-3 are Off.
•
when DIP switch 2-3 are On.