Unisys E-@CTION EFP9800 - Manual (Page 38)

Operating the Printer
2–16 3255 4073–002
Procedure
The paper low sensor lights the paper low/out LED when the paper roll is
almost empty.
You can raise or lower the paper low sensor assembly to change the amount of
paper left on the roll when the sensor lights the paper low/out LED. Raise the
assembly by turning the screw counterclockwise to signal paper low earlier
(more paper left on the roll). Lower the assembly by turning the screw
clockwise to signal paper low later (less paper left on the roll).
You need a Phillips head screwdriver to make this adjustment.
1. Open the rear cover.
2. Turn the screw on the paper low assembly to raise or lower the sensor,
changing the amount of paper that will be left on the roll when the sensor
activates the paper status LED.
3. See the table for more information.
4. Close the cover.
Paper Low Sensor Setting Amount of Paper Left
Factory Setting 8 ± 5 feet
Screw turned 1 revolution
clockwise 5.5 feet less paper (before
sensor is activated)
Screw turned 1 revolution
counterclockwise 5.5 feet more paper (before
sensor is activated)
Screw turned all the way down
(clockwise) Paper Low Sensor disabled
Note: These settings are based on the Receipt-Journal printer using two-ply
paper and the Receipt printer using one-ply paper. If paper is used
with different number of plies than specified, the information in the
table will not be accurate.