Unisys E-@CTION EFP9800 - Manual (Page 46)

Diagnostics and Print Tests
3–8 3255 4073–002
Switch
Pack
Switch
1
Switch
2
Switch
3
Switch
4
Switch
5
Switch
6
Switch
7
Switch
8
1 OFF OFF OFF OFF OFF OFF OFF ON
2 OFF OFF OFF OFF OFF OFF ON OFF
3 OFF OFF OFF OFF OFF OFF ON ON
4 OFF OFF OFF OFF OFF ON OFF OFF
6. Press the Paper Feed button.
The green Slip In LED turns off.
7. Set the DIP switches to the settings on the switch pack for the emulation
you have already chosen.
8. Use the tables in the following four sections (as listed under number five
above).
9. Press the Paper Feed button.
The green Slip In LED turns on. The internal switch pack and switch
settings you chose are stored in NVRAM.
10. Turn the printer off and reset the DIP switches to what they were when you
started.
For normal operation settings, see “Setting Switches” in Section 5.
11. Turn the printer back on.
12. Repeat this procedure to select settings on a different switch pack.
You can print out a listing of the settings you’ve chosen using the diagnostic
print tests. For more information, see “Diagnostic Print Tests” later in this
section.
Use the print test to print the name of the emulation which is currently active
and the settings of the NVRAM switch packs. See “Diagnostic Print Tests” later
in this section for information about running the tests.