Unisys E-@CTION EFP9800 - Manual (Page 167)

EFP9800 ESC/POS Commands
3255 4073– 002 6– 77
•
If a character set is being copied to flash memory, both the 7x7 and 5x9
versions of the character set are copied. The character set must have at
least one user-defined character defined to be copied.
•
The current state of the user-defined characters is preserved when the
command is performed. For example, if the user-defined characters have
been selected (by the Select/Cancel User-Defined Character Set
command— 1B 25 01) then, when the character set is restored from flash
memory, those user-defined characters will still be selected. If the user-
defined characters have been canceled by the same command, they will
remain canceled when the character set is restored from flash memory.
•
The current code page (not a user-defined character set) is saved, and
restored to RAM when the characters are read from flash memory.
Disable Loading the Object to RAM When Powering on the Printer
Retains the downloaded object in flash memory and does not copy it to RAM
when the printer is powered up. The object remains in flash memory and is
available to be copied to RAM later. The object will be lost if a new object is
copied into flash memory.
Hexadecimal Decimal ASCII
1B 7D 01 27 125 1 ESC } SOH