Unisys E-@CTION EFP9800 - Manual (Page 216)

EF4270 Emulation Commands
9–12 3255 4073–002
Buffer Clear
Clears all print characters and control codes from the buffer. All current
settings are maintained. This command does not return the printer to its default
condition. The command is processed immediately.
Hexadecimal Decimal ASCII
1B 60 27 96 ESC ‘
Repeat Character
Repeats any printable characters or control codes up to 255 times. This
command is best used to send several Line Feed commands (0A), or to print a
single character a certain number of times.
Hexadecimal Decimal ASCII Value of c Value of n
1F c n n n 1F 31 c n n n 31 US c n n n US Control Code
or Character 30-39 Hexadecimal
48-57 Decimal
0-9 (ASCII)
To send 101 Line Feed commands, send the following string:
1F 0A 31 30 31 1F
where 1F starts the command, 0A indicates the Line Feed command, 31 (Hex)
equals ASCII 1, 30 (Hex) equals ASCII 0, 31 (Hex) equals ASCII 1 (thus 101
indicates the number of times to repeat the Line Feed command), 1F stops the
command.
Wait for Slip
Puts the printer into slip waiting mode. The Slip In LED blinks until a slip is
inserted or the waiting is cancelled. When a slip is detected by both sensors, the
printer delays for a few seconds, and then closes the forms assembly. The delay
is determined by the Clamp Delay (1B 4C) command. Printing begins 0.18
inches from the top of the form. If concurrent feed is selected, both the cut
sheet and the paper roll feed.
Hexadecimal Decimal ASCII
1B 7C 27 124 ESC |