Unisys E-@CTION EFP9800 - Manual (Page 179)

Ithaca Peripherals Proprinter Emulation Commands
3255 4073–002 7–11
Set Single Line Double-Wide
Doubles the width of the currently selected character size. The table below
shows the available character sizes. You can change character size in the middle
of a line. The command stays in effect until it is canceled with the Cancel Single
Line Double-Wide command (14) or until the line is printed.
To return to single-wide characters, use the Cancel Single Line Double-Wide
(14) command.
Hexadecimal Decimal ASCII
0E 14 SO
Original Character Size Doubled Character
Size
10 characters/inch 5 characters/inch
12 characters/inch 12 characters/inch
17.2 characters/inch 8.5 characters/inch
Original Character Size Maximum Characters/Line
10 characters/inch 24 characters/line
12 characters/inch 28 characters/line
17.2 characters/inch 40 characters/line
5 characters/inch 12 characters/line
6 characters/inch 14 characters/line
8.5 characters/inch 20 characters/line
Set 17.2 Characters/Inch
Sets the character size to 17.2 characters/inch. You can change character size in
the middle of a line.
To double the width from 17.2 characters/inch to 8.5 characters/inch, use the
Set Single Line Double-Wide (0E) command. To return to single-wide
characters, use the Cancel Single Line Double-Wide (14) command.
Hexadecimal Decimal ASCII
OF 15 SI