Unisys E-@CTION EFP9800 - Manual (Page 42)

Diagnostics and Print Tests
3–4 3255 4073–002
Switch Entry Mode
Use Switch Entry mode to set the printer emulation or the internal switch pack
values in NVRAM.
Note: For an alternate method to set the emulation and switch settings, see
“Section 10: Flash Download Commands.”
The EFP9800 printer can emulate the following printers and emulations:
•
Epson ESC/POS (370/5) printer
Note: This emulation is included in the EFP9800 ESC/POS
commands.
•
Ithaca Peripherals Proprinter emulation
•
NCR 5021 printer (EFP984x Serial Interface Units Only)
•
EF4270 printer
Note: The EFP9800 FLASHADMIN software utility can also be used for
emulation and internal DIP switch configuration. This utility is
included in the EPF9800-SW1 style package.
The EFP9800 printer has one set of DIP switches, while some of the emulated
printers have two or more sets. You can enter values for the extra switch packs
into “internal switch packs” stored in NVRAM.
Note: Secure the roller assembly in a closed position to eliminate the
nuisance noise from occurring when the take-up assembly is not
being used.
All procedures completed in Switch Entry mode include two steps:
•
First, tell the printer what you want to do—either choose an emulation or
choose an internal switch pack value. (For example, choose the Ithaca
Peripherals Proprinter emulation or internal switch pack 2.)
•
Second, enter the value for the operation—either the specific printer
emulation or the values for the internal switch pack.
Both steps are completed by setting the DIP switches. During the first step, the
Slip In LED is on. During the second step, the Slip In LED is off.
Once you’ve finished setting options in Switch Entry mode, turn off the printer
and set the DIP switches back to the settings for the appropriate
communication protocol. The options you set in Switch Entry mode are stored
in “internal switch packs” in NVRAM until you change them.