Unisys E-@CTION EFP9800 - Manual (Page 168)

EFP9800 ESC/POS Commands
6– 78 3255 4073– 002
Enable Loading the Object When Powering on the Printer
Enables the object in flash memory to be copied to RAM when the printer is
powered up or the Initialize Printer command (1B 40) is received. This
command reverses the previous command, “ Disable Loading the Object to RAM
When Powering on the Printer” (1B 7C 01). The command is ignored if nothing
has been copied to flash memory.
Hexadecimal Decimal ASCII
1B 7D 02 27 125 2 ESC } STX
Copy the Object from Flash Memory to External RAM
Copies the object stored in flash memory directly to RAM. The printer does not
need to be rebooted, either by powering it off and on, or by sending the
Initialize Printer command (1B 40). The command is ignored if nothing has been
copied to flash memory.
The command performs whether the object has been enabled or disabled with
the two previous commands.
This command is similar to the Define Downloaded Bit Image command (1D
2A) and the Define User-Defined Characters command (1B 26), except that the
object comes from flash memory.
Hexadecimal Decimal ASCII
1B 7D 03 27 125 3 ESC } ETX