Unisys E-@CTION EFP9800 - Manual (Page 114)

EFP9800 ESC/POS Commands
6– 24 3255 4073– 002
Select Paper Sensor(s) to Stop Printing
Selects the paper sensor(s) used to stop printing when the paper-end is
detected. The printer finishes printing the current line and feeds the paper
before stopping. After a paper sensor is enabled, printing is stopped only when
the corresponding paper is currently selected. If multiple sensors are enabled,
printing stops when any one detects a paper end.
When the DSW2-3 (DIP switch) is set to Off and the journal paper sensor signals
a paper end, the printer goes offline after printing stops. When the slip sensor is
enabled and there is not enough paper for the next print instruction, the printer
ejects the paper and enters the paper waiting state.
Hexadecimal Decimal ASCII
1B 63 34 n 27 99 52 n ESC c 4 n
Sensor Status
Bit Sensor 0 1
0 Receipt/Journal Paper Near-End Disabled Enabled
1 Receipt/Journal Paper Near-End Disabled Enabled
2-4 Undefined
5 Slip (Detects Slip Ejection) Disabled Enabled
6 Undefined
7 Validation (Detects Validation Ejection) Disabled Enabled