Unisys E-@CTION EFP9800 - Manual (Page 67)

Diagnostics and Print Tests
3255 4073–002 3–29
Continuous Slip Printing
This test prints a slip, stopping each time the end of the slip is sensed and
continuing when a new slip is inserted. The printout includes all ROM CRC,
internal switch pack, and configuration information (same as the Print
Configuration Information test). See the sample printout later in this section.
1. Turn the printer off.
2. Turn the printer to the back to access the DIP switches and write down the
current switch settings.
3. Set the DIP switches to the following settings:
Switch
1
Switch
2
Switch
3
Switch
4
Switch
5
Switch
6
Switch
7
Switch
8
ON OFF N/A ON ON OFF N/A N/A
4. Turn the printer back on.
The Slip In LED flashes until a slip is inserted. When the slip is positioned
correctly, the Slip In LED is on steady.
5. Press the Paper Feed button.
The printer prints the slip. When the printer senses the end of the slip,
printing stops.
6. Remove the slip and insert a new one to continue the test.
OR
Turn the printer off to stop the test.
7. Turn the printer off and reset the DIP switches to what they were when you
started.
For normal operation settings, see “Setting Switches” in section 5.
8. Turn the printer back on to begin normal operation.