Unisys E-@CTION EFP9800 - Manual (Page 211)

EF4270 Emulation Commands
3255 4073–002 9–7
Reset Printer
This command is processed immediately and causes the printer to reset and
initialize as if the power had been interrupted. All data in the buffer will be lost.
The printer sends an XOFF if XON/XOFF handshaking is selected.
No additional data should be sent to the printer following the reset command
until one of the following:
•
The BUSY line toggles (parallel interface).
•
The RTS line toggles (RS-232 serial interface with RTS/CTS hardware
handshaking selected).
•
The printer sends an XON (RS-232 serial interface with XON/XOFF
handshaking selected).
If the unit is configured for XON/XOFF serial interface handshaking, the printer
also toggles the RTS line in addition to sending the XOFF/XON.
The printer reinitializes with the default DIP switch settings.
Hexadecimal Decimal ASCII
1B 00 27 0 ESC NUL
Cash Drawer 1
Opens the cash drawer. If a Y-cable is used to split the cash drawer connector
so two cash drawers can be connected to the printer, the cash drawer
connected to the first connector (labeled 1 or A) will be opened. See “Chapter 5:
Communication” for more information.
Hexadecimal Decimal ASCII
1B 07 27 7 ESC BEL
Cash Drawer 2
Opens the second cash drawer. If a Y-cable is used to split the cash drawer
connector so two cash drawers can be connected to the printer, the cash
drawer connected to the second connector (labeled 2 or B) will be opened. See
“Chapter 5: Communication” for more information.
Hexadecimal Decimal ASCII
1B 08 27 8 ESC BS