Unisys E-@CTION EFP9800 - Manual (Page 81)

3255 4073–002 5–1
Section 5
Communication
In order for a receipt or slip to be printed, a program must be in place that
translates the data from the host computer into a language the printer can
understand. This program must tell the printer exactly how to print each
character. This section describes how to create such a program or modify an
existing one.
Interfaces
In order for the printer to communicate with the host computer, a
communication link must be set up. The EFP9800 supports the following
industry standard interfaces:
•
RS-232C interface
•
1EEE 1284 parallel interface
Sending Commands
Once the communication link is established, commands can be sent to the
printer. This section describes how to send commands to the printer using DOS
and BASIC. This section does not take into account the necessary protocol— it
is meant as a general introduction to how the printer functions.
Using DOS to Send Commands
One way of getting commands to the printer is to send them directly from DOS.
For example, the command:
COPY CON: COM1:
means that the hexadecimal code corresponding to any key that is pressed is
sent to the RS-232C communication port COM1 when the COPY mode is exited.
If the printer is connected to COM1 and the communications modes match,
then the data will go to the printer.