Unisys E-@CTION EFP9800 User Manual
Page 58
Diagnostics and Print Tests
3–20
3255
4073–002
3. Set the DIP switches to the following settings:
Switch
1
Switch
2
Switch
3
Switch
4
Switch
5
Switch
6
Switch
7
Switch
8
ON OFF OFF ON OFF ON OFF OFF
4. Turn the printer back on to put the printer in Data Scope mode.
The red Paper Status LED blinks once to indicate that the printer is in Data
Scope mode.
5. Turn the printer off and reset the DIP switches to what they were when you
started.
For normal operation settings, see “Switch Settings” in section 5.
6. Turn the printer back on.
7. Run a transaction from the host computer.
All commands and data sent from the host computer are printed as
hexadecimal characters as shown.
You can check that the Data Scope mode parameters have been stored in
NVRAM by printing out the configuration information. For more information,
see “Diagnostic Print Tests” later in this section.