Unisys E-@CTION EFP9800 - Manual (Page 95)

EFP9800 ESC/POS Commands
3255 4073– 002 6– 5
Horizontal Tabs: Skip to Next Tab Stop
Skips to the next horizontal tab stop. The command is ignored unless the next
horizontal tab position has been defined. Default tab stops are every 8 columns.
Hexadecimal Decimal ASCII
09 9 HT
Standard Mode
If there are no more tab stops before the end of a line when this command is
received, the print starting position will be set to the beginning of the next line.
In other words, a line feed will be performed.
Page Mode
If there are no more tab stops before the end of a line when this command is
received, the print starting position will be set to the end of the current line.
Any subsequent character received will cause an auto-line feed to be performed.
For more information see “Page Mode” later in this section.
Line Feed
Hexadecimal Decimal ASCII
0A 10 LF
Standard Mode
Prints the data in the buffer and feeds the paper one line.
Page Mode
Sets the print starting position to the beginning of the next line. For more
information see “Page Mode” later in this section.