Unisys E-@CTION EFP9800 - Manual (Page 103)

EFP9800 ESC/POS Commands
3255 4073– 002 6– 13
Select Peripheral Device
Selects or cancels a peripheral device designated by the value of n. When the
printer is not selected, it reads all data but performs nothing except the Real
Time Status Transmission or Real Time Request to Printer commands. Even
though the printer is not selected, it may go offline through manual printer
operation.
Use internal switch pack settings to determine which value of n is selected. For
more information, see “ Switch Entry Mode” in section 3.
Hexadecimal Decimal ASCII Value of n
1B 3D n 27 61 n ESC = n 1-3
2 = printer not selected
1 or 3 = printer selected
Initialize Printer
Clears the buffer and resets the printer to the default settings as follows:
•
Resets the printer mode to the mode that was in effect when the power was
turned on.
•
DIP switches are not read again.
•
Data in the receive buffer is not cleared.
•
If slip printing is currently selected, the printer ejects the slip and switches
to receipt/journal printing.
Hexadecimal Decimal ASCII
1B 40 27 64 ESC @