ACU-RITE MILLPWR 2 Axes - Manual (Page 106)

PROGRAM STEPS
MILLPWR ®
Operation Manual 5-17
Face
The “Rectangular Face” step provides a quick way to face off the workpiece.
Simply enter the coordinates from one corner and either the size of the area to be
faced off or the coordinates for a diagonal corner.
MILLPWR will position the table
at the lower left end of the area you have programmed.
To program a rectangular face:
• Press the RECT key.
• Press the FACE softkey.
• Enter the X- and Y-axes coordinates for the face's 1 ST
corner.
• In the “Size” field, enter the length of the face along
the X- and Y-axes (unless you are programming a 2
ND
corner).
• Enter the depth.
• Select a tool offset by pressing the appropriate softkey.
• Enter the feed rate.
• If you wish to program a 2 ND corner and/or a tilt angle or would like to program a
finish cut, press the MORE softkey. Otherwise, press the USE key.
2 ND Corner
Enter the X- and Y-axes coordinates for the 2 ND
corner. (The 2 ND corner must be located diagonally
across from the 1 ST corner.)
Tilt Angle
Enter the tilt angle.