ACU-RITE MILLPWR 2 Axes - Manual (Page 73)

Programming the Contour
This part can begin at several different places. Begin at the upper-left corner,
and cut in a clockwise (CW) direction.
• Press the LINE key.
DEMONSTRATION
MILLPWR ®
• Using the keypad, enter the following information:
FROM : X1 = -3 ABS
Y1 = 1.5 ABS
TO : X2 = 0 ABS
Y2 = 1.5 ABS
DEPTH : Z = -.25 ABS
To enter a negative
number, use the
"±" key, not the "-"
or “+” key. The "-"
and “+” keys are
for performing
math operations
within a numeric
field.
Operation Manual 4-4