ACU-RITE MILLPWR 2 Axes - Manual (Page 59)

PROGRAMMING
MILLPWR ®
• Using the arrows, highlight the program you wish to load.
• Press the LOAD softkey.
If your G-code file is stored on a 3 1 /
2
” floppy disk:
• Insert the floppy disk containing the G-code file you want to load into the floppy disk
drive (located in the lower right-hand corner of the operator console).
• Press the USE FLOPPY softkey.
• Using the arrow keys, highlight the G-code file you wish to load.
• Press the LOAD softkey.
If your G-code is stored on a PC:
• Press the REMOTE STORAGE softkey. A "REMTSTOR" directory and any programs
it contains should appear.
If the REMOTE STORAGE softkey does not appear, then it is likely that MILLPWR and your PC
have not been setup properly (refer to Remote Storage and/or System Setup).
• Select the directory containing your program (refer to Selecting a Directory).
• Press the format key until G-code is displayed softkey. The screen will display all of the
G-codes files stored in the directory you have chosen.
• Using the arrow keys, highlight the DXF files you wish to translate.
• Press the LOAD softkey.
Note : G-code files are “run only.” No editing can be done to the file at the MILLPWR . All
editing should be done within your CAD/CAM program (refer to MILLPWR G-code
Conventions ).
Operation Manual 3-30