ACU-RITE MILLPWR 2 Axes - Manual (Page 118)

PROGRAM STEPS
MILLPWR ®
Operation Manual
Hole Frame and Hole Array
Hole frame and hole array patterns require the same information, but their patterns
differ slightly. Hole frames (shown on the left) limit holes to the outside edge of a
rectangular shape, while hole arrays (shown on the right) allow holes along the outside
edge and throughout the center.
Hole frames and hole arrays can be defined three ways:
• By the position of the 1 ST corner, size, and the number of holes
• By the position of the 1 ST corner, position of the 2 ND (diagonal) corner, and number
of holes
• By the position of the 1 ST corner, hole spacing, and number of holes
Choose the method that’s easiest for you based upon the information from the print.
To create a hole frame or hole array:
• Press the HOLES key.
• Press the FRAME softkey to program a hole frame; press the ARRAY softkey to
program a hole array.
5-29