ACU-RITE MILLPWR 2 Axes - Manual (Page 159)

CALCULATOR
MILLPWR ®
To save your GeoCalc results onto a 3 1 /
2
” floppy disk:
• From GeoCalc, press the CALC FUNCTIONS softkey.
• Insert a 3 1 /
2
” floppy disk into the disk drive.
• Press the USE FLOPPY softkey.
• Press the SAVE softkey.
If you have already saved the results from another GeoCalc session onto the 3 1 /
2
” floppy
disk, you will be asked if you want to replace what you previously saved. To save over the
older session, press the
YES softkey. If you don’t want to save over the older session, press
the NO softkey. Insert a new 3 1 /
2
” floppy disk and repeat the procedure.
Loading GeoCalc Results That You Previously Saved
Once the results have been saved from GeoCalc, you can reload them into GeoCalc at
any time.
To load GeoCalc results into GeoCalc from MILLPWR ’s internal memory:
• From GeoCalc, press the CALC FUNCTIONS softkey.
• Press the LOAD softkey.
To load GeoCalc results into GeoCalc from a 3 1 /
2
” floppy disk:
• From GeoCalc, press the CALC FUNCTIONS softkey.
• Insert a 3 1 /
2
” floppy disk into the floppy disk drive.
• Press the USE FLOPPY softkey.
• Press the LOAD softkey.
Operation Manual 6-8