ACU-RITE MILLPWR 2 Axes - Manual (Page 56)

PROGRAMMING
MILLPWR ®
Operation Manual 3-27
If the program is saved in a different directory:
• Press the CANCEL softkey.
• Press the PROGRAM FUNCTIONS softkey.
• Press the DIRECTORY softkey.
• Now press the SELECT DIRECTORY softkey.
• Using the arrow keys, highlight the directory that contains the program you want to
load.
• Press the SELECT DIRECTORY softkey again. The "DIRECTORY" screen will disap-
pear. Now that you have selected the appropriate directory, you can load the program.
• Press the LOAD softkey. The directory you chose should appear.
• Highlight the program you want to load, then press the LOAD softkey. The program
you selected should now appear on the screen.
From a 3 1
/ 2 " floppy disk:
• Save, then clear, any open programs.
• From the PGM screen, press the PROGRAM FUNCTIONS softkey.
• Insert the 3 1 /
2
" floppy disk containing the file you want to load into the floppy disk
drive. Located in the lower right-hand corner of the operator console.
• Press the DIRECTORY softkey and then press the SELECT DIRECTORY softkey.
• Press the USE FLOPPY softkey. The “A:” directory and any sub-directories should
appear.
• Select the directory that contains your program and then press the USE softkey.
• Press the LOAD softkey.
• Press the format key until MPT is displayed.
• Using the arrow keys, highlight the program you want to load. Press the LOAD soft-
key. The program you selected should now appear on the screen.