ACU-RITE MILLPWR 2 Axes - Manual (Page 133)

PROGRAM STEPS
MILLPWR ®
Operation Manual 5-44
• Notice that the screen is
divided into two sections—
“Text Block” and “Char-
acters.” You can switch
from one to the other by
pressing either the
TEXT
BLOCK or CHARACTER
softkey. Use the arrow keys
to move around within each
section.
• In the “Character” section,
highlight a letter, number,
symbol or space. Press the
ENTER key to make a selection. (The alphabet block on the left side represents
capital letters; the block on the right side represents lowercase letters.)
To add a space, move the cursor to a blank spot anywhere within the
"Characters" box and press the
ENTER key.
You can edit text by pressing the TEXT BLOCK softkey. Highlight the character
you want to edit, and then press one of the following:
The CLEAR key will delete a character.
The DELETE LINE softkey will erase the entire line of text that the cursor
is in and move all following text lines up.
The INSERT LINE softkey will insert a blank text line, moving existing
text lines down.
The CLEAR ALL softkey will erase all of the text in the text block.
• When you have finished creating/editing the text, press the EDIT TEXT softkey
(or press the USE key) to return to the “Engrave” screen. MILLPWR will display
the text that you have created on the right.
• Press the EDIT TEXT softkey if you want to make changes, or press the USE
key to add the engraving step to the program.
• Highlight a letter, number or symbol. Press the ENTER key after each selection.
(The alphabet block on the left represents capital letters; the block on the right
represents lowercase letters.)