ACU-RITE MILLPWR 2 Axes - Manual (Page 215)

TROUBLESHOOTING GUIDE
MILLPWR ®
Operation Manual 9-2
Operator console displays
a blank screen. Check that the power indica-
tor light, located in the upper
left-hand corner of the oper-
ator console, is illuminated.
If the power indicator light is
illuminated, either move the
table or press any key on the
operator console to restore
the display.
If the power indicator light is
not illuminated, power has
been interrupted. Follow the
recommendations for "No
Power."
Check that the power switch
located on the rear of the
operator console is on.
Check that the power cord is
properly connected.
Check that there are no
blown fuses or tripped
breakers.
Check that the main power
source meets the specifica-
tions required of the system.
In the event of a power inter-
ruption, you simply have to
wait until the power is
restored.
System has been idle for
approximately 20 minutes
and is in screen saver mode.
No power
Symptom
Recommended
Corrective Action
Probable Cause