ACU-RITE MILLPWR 2 Axes - Manual (Page 217)

TROUBLESHOOTING GUIDE
MILLPWR ®
Operation Manual 9-4
Operator console keypad
does not function properly.
System powers up, but
motor(s) will not move
table
Power down the system. Wait
for approximately one minute
then power the system up.
Remember to reestablish
machine tool zero using the
"Find Home" routine.
Run the Keypad Test (refer to
Diagnostics, Section 7).
Should the above recommenda-
tion not correct the problem you
are experiencing, contact your
ACU-RITE distributor for
repair and/or replacement pro-
cedures.
Check the message bar for the
following message:
“TABLE
STOP BUTTON IS PRESSED .”
Release the emergency table
stop button and press the
CLEAR key.
Review selections in "Run
Options.”
Review selections in "Run
Options.”
Check the message bar for the
following message: “DSP fault-
(X or Y) axis position error
check failed.”
Check the scale connections at
the motor assemblies.
System needs to be reset.
Emergency table stop button
has been pressed.
GRAPHICS ONLY selected in
"Run Options."
MANUAL POSITIONING
selected in "Run Options."
Improper scale connection
Symptom
Recommended
Corrective Action
Probable Cause