ACU-RITE MILLPWR 2 Axes - Manual (Page 184)

SETUP
MILLPWR ®
Operation Manual 7-15
To start the job clock:
• From Setup, highlight “Job Clock” then press the ENTER key.
• Press the START softkey, and the job clock will begin.
To stop the job clock:
• From Setup, highlight “Job Clock” then press the ENTER key.
• Press the STOP softkey, and the job clock will stop. The job clock’s current time will
be added to the value in the“Elapsed Time” field.
• To restart the job clock, press the START softkey.
To reset the job clock and the “Elapsed Time” field:
• From Setup, highlight “Job Clock” then press the ENTER key.
• Press the RESET softkey, and the job clock and “Elapsed Time” field will be cleared.
Job Clock
Note: The maximum
amount of time that the
job clock will record is
99 hours, 59 minutes
and 59 seconds. The
value will then roll
over to zero and con-
tinue counting.