ACU-RITE MILLPWR 2 Axes - Manual (Page 216)

TROUBLESHOOTING GUIDE
MILLPWR ®
Operation Manual 9-3
Operator console displays
a blank screen (continued)
Operator console displays a
flashing cursor
Contact your ACU-RITE dis-
tributor for repair and/or
replacement procedures
Remove the floppy disk
from the disk drive and cycle
power to the system.
Remember to use the "Find
Home" routine.
The system software has
been corrupted or may not
have been properly installed.
Re-install the system soft-
ware and power up the sys-
tem again. Remember to use
the "Find Home" routine.
Power up the system again
and check that the LED
(located on the front of the
floppy disk drive) is illumi-
nated. Also, listen for the
spinning sound that a floppy
disk drive makes when it is
being accessed.
Should the above recommen-
dations not correct the prob-
lem you are experiencing,
contact your ACU-RITE dis-
tributor for repair and/or
replacement procedures.
LCD display failure
A floppy disk is in the
floppy disk drive
System begins to power up,
but cannot get past flashing
cursor
The floppy disk drive is not
functioning properly
Symptom
Recommended
Corrective Action
Probable Cause