ACU-RITE MILLPWR 2 Axes - Manual (Page 186)

SETUP
MILLPWR ®
Operation Manual 7-17
Installation Setup
After selecting “Installation
Setup” from the “Job Setup”
list, you will be asked for a
passcode. The passcode is
located on the page before
the table of contents. You
can remove it and store it in
a separate location to prevent
accidental or unauthorized
adjustments to the system.
Once you’ve entered the
passcode, the “Installation
Setup” screen will appear.
Protection
Protection enables you to prevent unauthorized access to your
part programs and tool library. With “Part Program” and “Tool
Library” set to “Yes,” the part programs and tool library cannot
be altered—without first changing the “Part Program” and/or
“Tool Library”setting’s to “No.”
To change the protection settings:
• From Installation Setup, highlight PROTECTION then
press ENTER .
• Use the NO and YES softkeys to disable or enable protection for both the “Part
Program” and “Tool Library.”
• Press the USE key.
• Continue with Setup or press the USE NEW SETTINGS softkey.