ACU-RITE MILLPWR 2 Axes - Manual (Page 88)

DEMONSTRATION
MILLPWR ®
Operation Manual 4-19
Running the Program
The first step in running a new program is to establish datum.
Remember that to chose the center of the bolt circle as datum.
• Place the workpiece into a vise.
• Position the tool over the workpiece where you
want the center of the bolt circle’s datum to be.
• From the DRO screen, press the DATUM softkey.
• Press the X = 0 and Y = 0 softkeys to establish the
current tool position as datum, and then press the USE key.
• Return to the program by pressing the PGM key.
Perform a second dry run, this time allowing the table to move
to see if we have correctly set Zero.
• Press RUN OPTIONS then press DRY RUN .
Check that GRAPHICS ONLY is not selected.
• Now press the GO key and check that the tool is
clear of any obstruction.
• Press the GO key again. MILLPWR will run each
step without stopping.
If the cursor
is positioned
past the last
step, MILLPWR
will automati-
cally go to step
001 when you
press GO.