ACU-RITE MILLPWR 2 Axes - Manual (Page 167)

CALCULATOR
MILLPWR ®
Operation Manual 6-16
• Press the CANCEL key to return to the program. Check that the cursor is just below the
line previously programmed (item 001).
• Press the LINE key to begin a new “Mill Line” form. The “From” point is automatically
set at point B. The “X2” field should be highlighted. This is point C, one of the points
found in GeoCalc.
• Press the CALC key, then the GEOMETRY softkey.
• Highlight the GeoPoint representing point
C (step 004). Press the
RETURN FEATURE soft-
key. The program screen will return and point C’s
coordinates will appear in the “To” field.
• Press the USE key to accept the line into the part
program.
• Press the CALC key and then the GEOMETRY softkey.
The features in
the calculator
will not be
lost until the
MILLPWR is
turned off or
until you clear
the calculator.
Returning Features
Now bring the GeoCalc results back into the program. When you press the RETURN FEA-
TURE softkey, GeoCalc will transfer the feature you have identified into the part program.