ACU-RITE MILLPWR 2 Axes - Manual (Page 116)

PROGRAM STEPS
MILLPWR ®
Operation Manual
Hole Patterns
MILLPWR includes several built-in routines that let you program hole patterns quickly
and easily.
5-27
Row of Holes
A row of holes, can be programmed
two ways:
• By entering the coordinates of the
first and last hole
• By entering the coordinates of the
first hole, the spacing between
each hole and the row’s tilt angle
The “From” point refers to the center of the first hole, while the “To” point is the center of the
last hole. Any additional holes will be spaced equally between these two.
To program a row of holes:
• Press the HOLES key.
• Press the ROW softkey.
• In the "From" field, enter the X- and Y-axes coordinates for the center of the first hole.
• Now either:
Enter the X- and Y-axes coordinates for the center of the last hole in the “To” field; or
Enter the distance you want between each hole (from center point to center point) in the
“Hole Spacing” field. Also enter the tilt angle of the row of holes.