ACU-RITE MILLPWR 2 Axes - Manual (Page 203)

SETUP
MILLPWR ®
Operation Manual 7-34
The keypad test verifies that all of the keys, the remote pendant switch and the optional
electronic edge finder are functioning properly.
When you press a key, the corresponding graphic should shrink; when you release the key,
the graphic should return to its full size. If the graphics don’t change at all, it is likely that
the key is not functioning properly. If the graphic shrinks, but does not return to normal
when the key is released, the key may be sticking. Bullets (•) mark the keys that have
already been tested.
Keypad Test
To run the keypad test:
• From the Diagnostics screen, highlight "Keypad Test" and press ENTER .
• Press the key(s) on the keypad that you want to test. Press the remote pendant or use the
electronic edge finder to test their status.
• Press the CANCEL key on the keypad twice to exit the “Keypad Test” screen.
• Continue with Diagnostics or press the USE NEW SETTINGS softkey.