Extron Electronics MAV Plus series Large Scale User Guide - Manual (Page 100)

Programmer’s Guide, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Programmer’s Guide 4-12
Command/response table for SIS commands (continued)
Command ASCII command
(host to switcher)
Response
(switcher to host)
Additional
description
Audio mute commands
Audio mute X@
*1Z Amt
X@
*1
]
Mute output
X@
audio
(audio off).
Audio unmute X@
*0Z Amt
X@
*0
]
Unmute output
X@
audio
audio on).
Read audio mute X@
Z
X#] 1 = mute on, 0 = mute off.
Save, recall, and directly write global and room presets
N • If you try to recall a preset that is not saved, the matrix switcher responds with the error code E11.
• If you try to save a room preset for a room that has not been created, the switcher responds with the error code E11.
• The following characters are invalid in preset names: + - , ` @ = [ ] { } ‘ “ ; : | \ and ?.
Save current configuration
as a global preset X(, Spr
X(] Command character is a
comma.
Example: 9 , Spr9 ] Save current ties as preset 9.
Recall a global preset X(. Rpr
X(] Command character is a
period.
Example: 5 . Rpr05 ] Recall preset 5, which
becomes the current
configuration.
Direct write process for a global preset —
N The direct write of a global preset should always be preceded by a clear global preset ties command of that same
preset number, as shown below. In a directly-written preset, each output position’s tied input (or no tied input) remains
unchanged unless overwritten or cleared.
If you do not clear the ties in a global preset number before you directly write a global preset to that number, ties that
are part of the previous version of the specified preset with the same number can unexpectedly become part of the newly-
created preset.
Clear a global preset’s ties E + X( P0*! } Spr X(] Clear all ties in preset X( .
Directly write a global preset E
+
X(
P
X!
*
X@
!
X!
*
X@
%
X!
*
X@
$ ...
X!
*
X@
%
} Enter as many ties as are
valid for this configuration.
The ! tie all, & tie RGB,
% tie video
, and $ tie audio
commands are all valid.
Spr
X(]
Example: E
+27P0*!
}
Spr27
] Clear all ties in preset 27.
+27P2*5!10*9$13*11%3*10& Esc Brackets are shown to
separate ties for clarity only.
Create global preset 27,
which ties video and audio
input 22 to output 5,
RGBHV input 15 to output 29,
video input 13 to output 26,
and audio input 3 to output 8.
Spr27
]
N
X!
= Input number for tie 01 – (maximum number of inputs for your model)
X@
= Output number 01 – (maximum number of outputs for your model)
X#
= Mute status 0 = off, 1 = on
X(
= Global preset # 01 – 64