Extron Electronics MAV Plus series Large Scale User Guide - Manual (Page 15)

1-5 CrossPoint 450 Plus and MAV Plus Switchers • Introduction
Features
Video (video BMEs) — All switchers input and output video on BNC connectors.
• CrossPoint 450 Plus wideband video — These switcher BMEs input and
output wideband RGBHV or RGBS video. They can also switch RGsB,
RsGsBs, component/HDTV, S-video, or composite video.
• MAV Plus low resolution video — These switcher BMEs input and output
NTSC 3.58, NTSC 4.43, PAL, or SECAM video or HDTV video inputs.
Depending on the video format of the switcher system, these switchers can
distribute low resolution RGsB, RsGsBs, component/HDTV, S-video, or
composite video.
Bandwidth —
• CrossPoint 450 Plus wideband video — The wideband switcher BMEs
provide a minimum of 450 MHz (-3 dB) video bandwidth, fully loaded.
• MAV Plus low resolution video — The low resolution switcher BMEs
provide a minimum of 150 MHz (-3 dB) video bandwidth, fully loaded.
Audio inputs (audio BMEs only) —
• Stereo audio BMEs — Input and output balanced or unbalanced stereo audio
on 3.5 mm, 5-pole captive screw terminals.
• Mono audio BMEs — Input and output mono audio on 3.5 mm, 3-pole
captive screw terminals.
Audio input gain/attenuation (audio BMEs only) — Individual input audio
levels can be adjusted so there are no noticeable volume differences
between sources. Users can set the input level of audio gain or attenuation
(-18 dB to +24 dB) via the LAN port, either serial port, or the front panel.
Audio output volume (systems with audio BMEs) — The audio volume of each
output can be displayed and adjusted through a range of full volume to
completely silent, from the front panel or under serial or Ethernet port
control.